How to use the syringe

Syringe preparation

1. Place the syringe in the reset box and make sure that the green safety ring is in the "safe" position.

2. Close the reset box and press the syringe.

3. Open the reset box and remove the pressurized syringe.

Ampoule

1. Remove the adapter from the aseptic pack.

2. Thread the needle of the adapter into the rubber gasket of the vial to ensure that the adapter is secured in that position.

3. Remove the ampoule from the aseptic pack and pull the ampoule out half.

4. Open the cover of the adapter and rotate the ampoule until it enters the top of the adapter opening.

5. Push the vials and ampoules back and push the pistons all back into the ampoules. 6. Slowly pull the piston until there is sufficient dose in the ampoule and no air bubbles.

Ready to inject

1. Unplug the ampoule from the adapter and close the adapter cover.

2. Rotate the ampoule to the open end of the syringe. Note: When the ampoule is tightened, the first safety mechanism will fail.

3. Push the green safety ring to the "safe off" position, the second safety mechanism will fail. The syringe is ready for use.

injection

1. Place the syringe vertically at an angle of 90 ° to the injection site, pressing the skin and taking the top of the ampoule completely into the skin.

2. When the trigger is pulled, the syringe is stably held at the injection position for 2 seconds after injection.

3. Unplug the ampoule, the ampoule after use can be treated as daily garbage. Push the green safety ring back to the "safe" position.

Taizhou thousands of Johnson Plastic Co., Ltd. is a commitment to the medical aspects of research and development, production and sales as one of the modern enterprise! The company mainly engaged in: pet chip syringes, medical silicone O-ring, medical medical plastic products!